Thanks for the info. If you don't mind, where are they made?
The spokes are the highest stressed part of a wheel, is the spoke area touched by the rollers or is it just cast?

 

Posted previously but I know not everyone reads all the post...

manufactured in Taiwan

We are currently working on gaining TUV approval in 2016....

 

The wheels I had issues with were Taiwanese wheels made by Ace Wheel Company

http://www.acealloywheel.com

I think that's a great offer for Wheel Dynamics to offer to test these for run-out and high-low on their wheels. That's the major concern, and if they can document those satisfactorily then you'll probably have a good experience with ownership of them.

 

We have a set on our shop car we can but it will not be sensible to remove that set already installed, so we will perform a bare-rim balance using the Hunter 9700 3D-Monitor and laser assisted system.

We should have this set ready sometime later this week.

For now, I'll post a couple of photos on the Porsche!