When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Can someone with "model designation delete" from Factory replicate the same measurement as in my picture and report back with correct factory measurements?
Specifically looking for the measurement from the top of letter "P" to the first line in bumper ( See Arrow on tape). Currently I am at 2.5" and I feel that is too low, need to redo the whole thing. I DO know that all letters are at a different height but letter "P" should give me a good starting point.
Thank you in advance
Demosta - just measured. The pic you have is way low. I measured from the edge as pictured to the top of the P and it is 1 1/8". The letter itself is 7/8 inch.
Demosta - just measured. The pic you have is way low. I measured from the edge as pictured to the top of the P and it is 1 1/8". The letter itself is 7/8 inch.
Thank you sir. I was sure it was too low, just didn't know exactly how low.
I have to say, I was going to do precision measurements and plan on an hour and a half to do it on a nice sunny day. Then I said "F-it", I'll just go out in the garage and do it, about 10 p.m same night they arrived from Suncoast. I think it took me 15 minutes and I just used a tape measure. The key is - the letters are on a subtle curve. I just eyeballed mine. They came out just fine - if its off, I don't see it.
I have custom emblems on my car and they are not in the OEM positions. Seriously though the information is in this forum: search on "porsche emblem" and read a few threads. Did you read this forum from the start?
Why would we do that when we can sip a scotch and wait for you to give us the info we desire?
Thank you sir. I was sure it was too low, just didn't know exactly how low.
Thanks again for taking the time
My T came with model delete and Porsche seems to be in the same location as yours per your pic. I added 911 carrera T not knowing all this so it is off on the low side. Looks just fine however. Debating about going back to just Porsche on the rear or adjusting to factory specs. 1st world problems!🙄
12-15-2020, 01:20 PM
