Hello, looking for a 991.2 and found this one for sale have never seen this aftermarket exhaust.

Can someone tell me what it might be?

 

Possibly: Specialty Precision exhaust..

https://specialtyprecisionwelding.co...center-exhaust

 

3D Printed at MIMO Technik.

 

 

The rear valance allows you to use GT3 / GT3RS or GT3 compatible exhausts on the Carrera rear bumper.
it converts the PSE valance insert to a center exit insert.
Its 3D printed in AL. Can be painted all black or black and silver ( as pictured )

 

Any sound clips?

 

We offer this exhaust system and 3D Metal printed diffuser section.

Will post a sound clip shortly for you guys

 

Does it take the place of the exhaust surround section on the valance? I looked at mine at while back and could not see a way to take it off.

 

@Bob Z. You have to unclip the standard PSE insert, and Clip in the new AL Center exit insert. Its pretty simple.

 

I'll look again but I did not see how to do it!

 

Do it properly. Go to a commercial audio rental place (most music instruments store also do) and rent a good quality microphone with a huge wind protector and a digital recorder.

Put that cell phone away, it’s crap.

When recording:

- If standing still, keep the microphone at least 12 to 15 feet away. That’s how you capture the bass in the spectrum.

- if doing drive-bys, make sure that the closes the car gets to the microphone (when the car passes in front) it’s still at least 9 feet away.

- do a cabin recording with the microphone in the middle of the car, halfway between the ears of the driver and passenger.

 

I was talking about the trim piece in the center of the valance.

 

My bad. I guess I was reading sideways and saw the word "clip" whn you wrote "unclip" and thought you were talking about recording the sound.

Too many people request sound clips and all we get is awful cellphone recordings.

Alright, back to the subject at had. Please ignore my ADHD.

 

PM'd

 

A quick video