Cantrell Motorsports roll bar
#77
Is it straightforward to cut the carpet to access the mounting points, or is there a carpet cutting template provided to help?
#78
I was back in Cantrell today getting a track alignment. The bars are now at the powder coater and should be done this week. Colin and I talked about the bar install today. One of my concerns was loosing the rear storage area for say a long road trip. He said with removal of just two bolts on the aft tubes you can remove the cage. Ok it will take a little work but you leave the side pillar mounts in place and just clip out the cage. Fantastic.....
I have Jesse at Sunset Porsche parts looking into Euro Club Sport parts. You should only need the carpet piece and the two lower plastic pieces with the bar cutout. If we could get these we could keep our original factory parts and uses these when we want to go back to stock, Voila !!!
I have Jesse at Sunset Porsche parts looking into Euro Club Sport parts. You should only need the carpet piece and the two lower plastic pieces with the bar cutout. If we could get these we could keep our original factory parts and uses these when we want to go back to stock, Voila !!!
#80
Colin Cantrell
#81
I was back in Cantrell today getting a track alignment. The bars are now at the powder coater and should be done this week. Colin and I talked about the bar install today. One of my concerns was loosing the rear storage area for say a long road trip. He said with removal of just two bolts on the aft tubes you can remove the cage. Ok it will take a little work but you leave the side pillar mounts in place and just clip out the cage. Fantastic.....
I have Jesse at Sunset Porsche parts looking into Euro Club Sport parts. You should only need the carpet piece and the two lower plastic pieces with the bar cutout. If we could get these we could keep our original factory parts and uses these when we want to go back to stock, Voila !!!
I have Jesse at Sunset Porsche parts looking into Euro Club Sport parts. You should only need the carpet piece and the two lower plastic pieces with the bar cutout. If we could get these we could keep our original factory parts and uses these when we want to go back to stock, Voila !!!
#82
GT3 player par excellence
Lifetime Rennlist
Member
Lifetime Rennlist
Member
norcal group, colin did confirm powder coating be done end of this week. he and i are riding the powder coater hard. i may have to fly up and physically threaten the powder dude.
once they show up, u will get my pm to pick up or to be installed.
once they show up, u will get my pm to pick up or to be installed.
#85
GT3 player par excellence
Lifetime Rennlist
Member
Lifetime Rennlist
Member
norcal batch, our bars are shipping tuesday. i will ping you all for pick up or install on friday
i hope we dont get snowed in b/n WA and CA
you never know. rough weather everywhere.
i hope we dont get snowed in b/n WA and CA
you never know. rough weather everywhere.
#87
Nordschleife Master
Thread Starter
Looking forward to seeing these bars in person. A few rennlisters have been scoping the bars out in person and have been impressed. We're just waiting for the powercoater to finish them up. I plan to start the install next weekend!
#88