est8esq

Has anyone figured out yet whether or not the inside cabin of the RS is the same as the regular GT3?

Will the 991 GT3 harness cage, bolt-on cage fit the RS variant?

James-GMG

Yes, our 991 GT3 bar will fit in the 991 GT3RS.
See below for a few examples:

gmgracing

One of our clients brought in his heavily tracked GT3 for a fresh set of sticky Hoosiers and a full inspection last week. While the car was in our facility I had the opportunity to take a few photographs emphasizing some of it's track mementos.

Of interest to this thread is a photo highlighting the rear portion of our popular GMG LMS Roll Bar. Since this bar is tied directly into the cross bulkhead of the chassis it makes for a very rigid setup. We pioneered this roll bar design and it has proven itself very effective since it's introduction.




For more current information regarding our 991 GT3 and GT3RS GMG LMS Roll Bar visit our website listing here.

To find a GMG-authorized installer near you, see our ever-expanding global dealer map here.

SanDiegoDavid

Ahh, I know that car. Mike, it's got that heavily tracked "patina".

porscheflat6

Best Patina for Porsche GT anything!

DES GTS

AP would definitely agree!

BTW, I think GMG meant to say "rigid" and not "ridged" in describing the roll bar.

gmgracing

Good catch on spotting that error DES GTS. It has now been corrected.