PET for 991.2 GT3 RS and 991 GT2 RS available?
#16
Rennlist Member
Thread Starter
End plates may be interchangeable. Porsche has already tried to mislead by showing the side intakes are not interchangeable between the 991.1 RS and 991.2 RS but JCR has already proven that wrong.
#17
Porsche sure protects the integrity of their variants. I was going to fit a set of carbon fiber 991 GT2RS rear intakes on my 991.2 GT3RS but it was not possible due to configuration differences.
#18
Rennlist Member
Thread Starter
#19
Suncoast was selling them as a direct replacement, but they are not a direct replacement, and Suncoast has taken them off their site. Suncoast should do their homework before hawking products they don't understand.
The following users liked this post:
Rob.Fri (12-29-2020)
#21
One observation with the wing end plates is that the GT2 RS has end plates that are adhesive onto the wing. The GT3 RS has two bolt holes on each side and actually come up from the bottom to hold the end plates on. So with two different mounting systems suspect it would be quite difficult to interchange.
Last edited by redmonkey928; 01-08-2021 at 12:48 AM.
#22
Not to highjack but this seems like the best place to ask; can swap a 991.2 RS wing on to my 991.1 RS? Do I need to do anything to the front to balance out downforce? Thanks my wing is all bubbles and I’m trying to decide on my best path forward.
#24
#25
Rennlist Member
The GT2 wing is a different part number as well: 991 512 265 70
It appears the struts are the same part for the .2 RS's.
I found a link to the parts book on line. The GT2 parts are shown in the latest Turbo parts book.
https://www.porsche.com/usa/accessor...originalparts/
It appears the struts are the same part for the .2 RS's.
I found a link to the parts book on line. The GT2 parts are shown in the latest Turbo parts book.
https://www.porsche.com/usa/accessor...originalparts/
I dont think this is valid anymore - I see no PET pages here?