Rennlist - Porsche Discussion Forums

Notices
964 Forum 1989-1994
Sponsored by:
Sponsored by:

964 Torque settings thread

Thread Tools
 
Search this Thread
 
Old 07-30-2017, 04:27 AM
  #16  
John McM
Rennlist Member
Thread Starter
 
John McM's Avatar
 
Join Date: May 2001
Location: Auckland, New Zealand.
Posts: 13,265
Received 603 Likes on 360 Posts
Default
Knock sensor rail. 10Nm. The rail should be installed loosely prior to head stud tightening otherwise the holes on the cylinder barrels may not line up properly.
Attached Images  
John McM is offline  
Reply Like
Old 07-30-2017, 04:31 AM
  #17  
John McM
Rennlist Member
Thread Starter
 
John McM's Avatar
 
Join Date: May 2001
Location: Auckland, New Zealand.
Posts: 13,265
Received 603 Likes on 360 Posts
Default
Head stud threads and head stud nut flanges covered with high temp grease. Torque to 15 Nm then turn 90 degrees.
Attached Images    
John McM is offline  
Reply Like
Old 07-30-2017, 04:35 AM
  #18  
John McM
Rennlist Member
Thread Starter
 
John McM's Avatar
 
Join Date: May 2001
Location: Auckland, New Zealand.
Posts: 13,265
Received 603 Likes on 360 Posts
Default
Nuts for timing chain cover 25 Nm
Attached Images  
John McM is offline  
Reply Like
Old 07-30-2017, 04:39 AM
  #19  
John McM
Rennlist Member
Thread Starter
 
John McM's Avatar
 
Join Date: May 2001
Location: Auckland, New Zealand.
Posts: 13,265
Received 603 Likes on 360 Posts
Default
Chain ramp pins 31 Nm
Attached Images   
John McM is offline  
Reply Like
Old 07-30-2017, 04:43 AM
  #20  
John McM
Rennlist Member
Thread Starter
 
John McM's Avatar
 
Join Date: May 2001
Location: Auckland, New Zealand.
Posts: 13,265
Received 603 Likes on 360 Posts
Default
Cam cover nuts 15 Nm.
Attached Images  
John McM is offline  
Reply Like
Back to Subforum
964 Forum
View Next Unread
Best replacement Led H4's?




Advanced Search
Quick Reply: 964 Torque settings thread


Reply Closed Thread Share
Forum Jump

All times are GMT -3. The time now is 04:17 AM.