964 Interior Thread: Share yours!
04-24-2014, 02:52 PM
#136
05-12-2014, 08:00 AM
#137
The Speedster wasn't a good one, it drove rather badly/ crept sideways, had a rather hard life, was noisy, creaky, jerky, hood was a pain, those RS seats suck if you're over 200 pounds, two tone grey leather reminds me of German footwear choices in the 1980's, ride and scuttle shake terrible. I think many people forget why certain cars are so rare - many cars didn't sell because they were just plain terrible when they were new. This was one of very few tiptronics. No prizes for guessing why. If you have medical reasons for Tiptronic fine otherwise you should go stick Anyway I digress...
Am waiting for my new backdate Gulf Porsche 964 dials to arrive...will post them up if/ when they're finished. The rev counter lay out is still WIP
Am waiting for my new backdate Gulf Porsche 964 dials to arrive...will post them up if/ when they're finished. The rev counter lay out is still WIP
05-31-2014, 04:35 PM
#143
Racer
I used cheap alcantara but UV resistant on all pieces,and spray glued some thin foam on the doorside material,just to get some 3d effect,and yes the dash need to be in two pieces otherwise it wont work to cover or at least i didnt managed to do it with one piece,and i used a twin needle for the stitch
Last edited by LimmetED; 05-31-2014 at 05:05 PM.
09-29-2014, 10:01 PM
#147
I had that exact wheel on my ROW 84 Carrera which had a blue interior and was a product of the wish department, everything was custom. I loved the wheel.
10-01-2014, 03:03 AM
#148
Three Wheelin'
I used cheap alcantara but UV resistant on all pieces,and spray glued some thin foam on the doorside material,just to get some 3d effect,and yes the dash need to be in two pieces otherwise it wont work to cover or at least i didnt managed to do it with one piece,and i used a twin needle for the stitch
For the twin needles, did you also need a double bobbin and base plate as sewing machines are generally designed for a single needle?
