America GS Consolidated Thread
#271
Rennlist Member
#272
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
This is the coolest thing I've ever seen! Great work!
#273
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Have had nothing to do with the Singer engine. As far as my own 4-valve air cooled engine goes, I have stopped work on it because I am too busy on other things. Also, I am trying to determine if anyone else is actually interested in buying such an engine or is it just for my own car.
#274
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
After a long hiatus to attend to other matters, everyone is back on the 4 valve engine project -- engineers in three countries are hard at work. Also, the rear anti roll bar in carbon fiber and titanium has been completed as well as a way to use equal length headers and have heat in a 964.
#275
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
After a long hiatus to attend to other matters, everyone is back on the 4 valve engine project -- engineers in three countries are hard at work. Also, the rear anti roll bar in carbon fiber and titanium has been completed as well as a way to use equal length headers and have heat in a 964.
#277
Rennlist Member
#280
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Bob,
I stopped by a few weeks back and saw the work being done. Would love to see the R when all is settled. Best luck with the engine project.
I stopped by a few weeks back and saw the work being done. Would love to see the R when all is settled. Best luck with the engine project.
#281
Professor of Pending Projects
Rennlist Member
Rennlist Member
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
I am just happy to see you continue to share updates on the progress.
#285
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Robert,
When I was doing my extensive exhaust development on the M64 engine, I never achieved the best results with equal length headers in regards to horsepower. Equal length gave a small percentage bump in torque between 4-4400rpm, but lost hp above 6000. I always achieved the best torque curve with 2 long primaries, 2 mid length, and 2 short.
When I was doing my extensive exhaust development on the M64 engine, I never achieved the best results with equal length headers in regards to horsepower. Equal length gave a small percentage bump in torque between 4-4400rpm, but lost hp above 6000. I always achieved the best torque curve with 2 long primaries, 2 mid length, and 2 short.