I FINALLY got around to putting on my Ultimate Pedals I bought last year as part of the group buy. I like them a lot, but the dead pedal is too big. I'll have to shave about 2 inches off the door side.
I also put new seals on the shark fin rocker panel; not a difficult job. The new seals have a ridge that fits into the back side groove. Made for an easier time holding the seal in place.

Here's a few before/after shots. After I was done, the car got a bath and a shine; no pictures of that though.

 

huh; not one comment either. Fine lot of troublemakers you are!

 

nice pedals

 

Sorry,

The subject line from your thread upset me. It reminded me I have been unable to post about any progress on my own project.

I feel you were being insensitive.

Kirk
p.s. Nice pedals by the way.

 

Actually, they were showcased in Racing/DE forum here: https://rennlist.com/forums/racing-and-drivers-education-forum/363573-throttle-pedal-extension-recommendation.html thanks to TR6 posting a link because he was too lazy, er busy to take his own pictures.

Nice lookin pedals!

Regards,

Steve

 

Nice pedals!

 

I'm not commenting because you have room to rest your left foot

 

Looks good Geoff !

 

I have to install the dead pedal, but after a small shave job on the plate. It's too wide to allow any secure mounting.

AND- I make no apologies for taking a year to complete a simple hr long project.