The For Sale/Trade/Wanted thread *Posting by paying Members only*! PRICES NEEDED.
#3916
Rennlist Member
The following users liked this post:
Peteinjp (11-03-2019)
#3917
Rennlist Member
This guy has a mod7 for sale.
https://rennlist.com/forums/market/1166085
https://rennlist.com/forums/market/1166085
Mr. Wolfe
#3918
I've ordered from them before. They're legit.
#3919
Rennlist Member
You can get those leather horn buttons from AASE Sales.
I've ordered from them before. They're legit.
I've ordered from them before. They're legit.
Mr. Wolfe
#3921
Rennlist Member
#3924
Three Wheelin'
^ Question for the uninitiated. Does that shifter replace the stock shift **** and boot or does a shift **** and boot somehow go over that when installed?
#3926
It is a single billet unit that replaces the **** and stalk. Most people use it without a boot, but it slips through the rubber bellows that is below the stock boot.
#3927
Rennlist Member
The following users liked this post:
SR20Fastback (12-02-2019)
#3929
I had an interior shop make one out of leather with deviated stitching for $100. If you wanted to be cheap, you could just cut the **** off your stock book and roll the cut edge under.
If you buy this, you should buy the golden rod as well. its not required, but the combo of the 2 is the best thing this side of the factory RS shifter IMO.
If you buy this, you should buy the golden rod as well. its not required, but the combo of the 2 is the best thing this side of the factory RS shifter IMO.
#3930
Bump these
Front suspension upgrade: 993 setup for the front of your 964.
Front control arms, balljoints, uprights (NOT 993 RS) and calipers.
All used and in good condition. One front caliper has marks where a ham fisted mechanicc pulled the seals out, but they do not impair function and are not visible when mounted.
You'll need your hubs and new bearings.
800$ plus shipping at cost from Switzerland.
Front control arms, balljoints, uprights (NOT 993 RS) and calipers.
All used and in good condition. One front caliper has marks where a ham fisted mechanicc pulled the seals out, but they do not impair function and are not visible when mounted.
You'll need your hubs and new bearings.
800$ plus shipping at cost from Switzerland.