Help mounting Montana plate on Euro Import 964
#1
Help mounting Montana plate on Euro Import 964
Hey all
New member here - have searched but only found solutions for front plates! Is there an easy/good way to affix new (Montana) plates on my Euro import 964 - ideally without drilling holes?
Any tips and/or recommendations would be much appreciated.
See image of current EU spec bracket.
FJ
New member here - have searched but only found solutions for front plates! Is there an easy/good way to affix new (Montana) plates on my Euro import 964 - ideally without drilling holes?
Any tips and/or recommendations would be much appreciated.
See image of current EU spec bracket.
FJ
#2
I also have a eurospec from Japan - same bumper. I don't have a bracket. I recall an issue with a factory plate bracket so I just drilled holes in my plate which line up with the expanding nuts on the bumper. I think I put some and tape on the back of my plate to protect the paint. After 7+ years and 2 or 3 new plate swaps there's been no issues. Maybe there's a bracket out there... but this is flush and lightweight... ah
The following users liked this post:
laranja (12-02-2023)
The following users liked this post:
misteralz (12-03-2023)