Caging Wilson
#79
Race Car
Thread Starter
Had ... barely, just barely enough material to do the rear "x". Notice the gussets at the bottom because it's really tough to get a quality weld on the underside so close to the floor pan!
#81
Race Car
Thread Starter
Had the pleasure of spending good time with my dad in North America's most sophisticated Porsche Dealership (located in Calgary, Alberta).
Incredible!
In the basement, there was many a cool used & vintage car section. Only half were p-cars. Found 2 RUF 911s. This yellow one & a really nice blue one. Both had cages.
I'm 6 feet tall. Note: the pipe location so close to my head. This is a bolt on cage. Also note the dash bar. I tested contact, and my knee would strike it easily. Cool car but the cage is substandard.
$129,000 cdn
Incredible!
In the basement, there was many a cool used & vintage car section. Only half were p-cars. Found 2 RUF 911s. This yellow one & a really nice blue one. Both had cages.
I'm 6 feet tall. Note: the pipe location so close to my head. This is a bolt on cage. Also note the dash bar. I tested contact, and my knee would strike it easily. Cool car but the cage is substandard.
$129,000 cdn
#82
Three Wheelin'
Nice, Yea, That's why I ran the "Knee bar" behind the Dash.. Oh BTW I couldn't help it.. Every time I see this post I think this is what you originally meant.