never noticed this before
#1
never noticed this before
It looks like the ducting that runs underneath my IC has come away from my rad.. Or, is it supposed to be that way? To me, it looks like the ducting should be butting right up against the top of the rad. But, I can see a gap there (pic included). It's hard to explain. Maybe somebody can check what their's looks like.
With the hood open, look just behind the IC (the bottom of the IC where it almost meets up with the top of the rad).
With the hood open, look just behind the IC (the bottom of the IC where it almost meets up with the top of the rad).
#2
That is pretty common. I think the factory provided clips between the duct and radiator to seal it, but in my experience over time they become misaligned which makes it difficult to fit replacement clips
#3
Yeah there's little metal spring clips that hold it in place.
Mine went missing at some point. I replaced them via binder clips from Office Depot. Intent has been to order the correct clips the next time I place an order @ Pelican. Just haven't had to order anything from Pelican in the last few months. Binder clips have been getting the job done.
Mine went missing at some point. I replaced them via binder clips from Office Depot. Intent has been to order the correct clips the next time I place an order @ Pelican. Just haven't had to order anything from Pelican in the last few months. Binder clips have been getting the job done.