Finished the wrap
#17
Three Wheelin'
Love the way it's turning out Devon but am a little worried about the wiring going to your battery. It looks like you have a wire going over the rubber seal and even worse one going underneath. This is really dangerous for obvious reasons. Drill a hole next to the other hole at the left of your build plate, put a grommit in it and then feed the wires through there. Hate to see your project come to any grief because of something so easily avoided
#19
Thread Starter
Rennlist Member
Joined: Feb 2002
Posts: 1,907
Likes: 0
Received 0 Likes
on
0 Posts
From: NY
Love the way it's turning out Devon but am a little worried about the wiring going to your battery. It looks like you have a wire going over the rubber seal and even worse one going underneath. This is really dangerous for obvious reasons. Drill a hole next to the other hole at the left of your build plate, put a grommit in it and then feed the wires through there. Hate to see your project come to any grief because of something so easily avoided
#20
Thread Starter
Rennlist Member
Joined: Feb 2002
Posts: 1,907
Likes: 0
Received 0 Likes
on
0 Posts
From: NY
stills and lower wing was easy as in damages in the paint since she's an old car I did do some sanding on the body . If I didn't do that you will see some of the imperfections. But with some sanding turned out very very good