When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
So far, 6 people have pre-ordered (thank you!). And it looks like possibly crazyz007 and ealoken will be in. So, I'm about to place an order for either 10 or 20 of them with the metal fabricator... I'm leaning toward ordering 20 since there is a setup fee for each batch, but don't want to sit on an extra 10 if nobody needs them, so... Anyone else need one of these?
I may be interested in the new model, but I would like it in stainless steel, is it possible?
Sorry, not at this time. If there is enough interest, I can have a batch of stainless ones made sometime. For now, I have 12 more black powder coated ones available. I'll post a pic soon.
Sorry, not at this time. If there is enough interest, I can have a batch of stainless ones made sometime. For now, I have 12 more black powder coated ones available. I'll post a pic soon.
just picked them up. here’s what they look looks like in black powder coat:
Got mine yesterday. Looks Fantastic installed today with new master clutch cylinder, DID NOT have to take of the brake booster off to install on my 968. I did have to file a little bit off the bolt hole on Left side "hole farthest from brake booster" to make the turn and fit.
Finally installed mine today. Like RichardK I also had to use a round file to slightly increase the bracket hole on the furthest from the brake booster side for my 87 951. Lengthwise fit was great against the strut tower and I was able to keep the booster in place. As a note the bracket is about 2.5mm thick so just add that additional length to the normal 147mm (LHD drive) + 3mm (firewall thickness) to get the ideal clevis/stop nut location.