ehall

Ahhh. How did it get rusty?. Anyway, it's not my car, so go for it!

lee101315

Looks good, did you also cut the front fender and 1/4 panel? How are you attaching the flares?

reno808

So nice

kghaas

The flares are just tape on to see how it looks. If I go for it I will have to cut both front and rear.
Also, this is to cure a paint issue/rust issue. This is due to a poor paint job, and using the car as a daily driver in winter conditions with tons of salt on the roads!

My impressions of the flares:
I might have mixed up front and rear flares...
2in is quite a lot. I will definitely need 295s or spacers.
The curve is quite ok
The look fits quite well with the car

Some detail shots:

CyCloNe!

Looks good, I've been wanting flares so your giving me ideas

CyCloNe!

Updates?

kghaas

If i do this, it wont happen until I have finished the Orange Seven in the background and rebuilt my Porshce engine, which basically places this project somewhere in the 2014-15 area...

Last pic is without 28mm spacer. Here it looks very much like the flares are mixed up...