Alpineace

can anyone show me a square on, pic of the bottom of the rear half of the 951? as if you turned the car on its side and took a picture.

Thanks!

Alpineace

anyone?

gruhsy

I'm trying to get you some off my piece of crap Mac Book Pro. They are there but corrupt. Going to try dig them of the back up drive.

MAC SUCKS. I may have them on my PC. I will have to go check if I get time.

gregeast

Probably not enough detail but hope it helps:

mclarenno9

Edit: Greg beat me to it!

Scott H

Mine's up on jacks right now so I could easily snap a picture but there is no tranny, axles, or brakes mounted right now. Would that still work?

Alpineace

thanks, kinda what I want but yes, not enough detail too low res.

Alpineace

it might if the exhaust is still in.
thanks!

Crazy Eddie

Best I can really do ....
Not really sure what your looking for as far as a picture?

Reimu

Suddenly feeling really self conscious about how my car looks like on the bottom

URG8RB8

I think your cat has lost a little luster Eddie, time for you to get to work!!!
& what is that on the fifth fin from the right on your oil pan?

My God, really??? Can't believe you actually take this masterpiece on the crappy Bay area roads.

Crazy Eddie

LOL

Actually, that was before I did all the work on the front end, in which everything your looking at, was removed ( for the umpteenth time)
The entire front end suspension was removed, and I replaced the oil pan gasket, LBS seals, Motor Mounts, Lindsey Segmented Crossover, and 968 caster block bearings....
So it looks a lot better now, then when I took that picture
But, I still have a dribble coming form the new oil pan gasket ... ( that is a stick in the eye if there ever was one )
Best regards guys
Ed

Darwantae951

Eddie, your car makes me want to roll mine off a cliff.

Crazy Eddie

LOL
Actually, I want to roll my car off a cliff more times than I care to admit..
I should have listened to you on the freakin oil pan gasket ( using yamabond etc)

Darwantae951

Uh oh. What happened?