vette951s

https://rennlist.com/forums/for-sale...isc-parts.html

or see post #5

shortyboy

Too bad I can't view it.

Max Energy

I can't view it either

JET951

member to member classifieds

vette951s

For those who are without a membership:

I've been putting off this decision for a time, but its time to realize my 968RS race car project is not to be and it is time for me to move on from racing. Besides the parts listed below, I've got a garage full of parts from parting a few 951S cars and a 944 cab, so don't hesitate to ask for anything (I can reclaim some garage space!). I'll be adding more parts to the list as I uncover them. Heck, I'll even be putting my Rothman Turbo Cup car up for sale soon.

All parts that are not noted as new are mostly near new with only a few days of track sessions on them. PM for more info/pics [give email addy!].

I've been a lister going way back to before the Rennlist days and have sold a few cars and probably at least $25,000 in parts without issue. All parts are shipped Fedex insured at cost from Napa, CA 94558 - CONUS only! Paypal is usually OK, but for the more expensive items lets talk.

Engine:
3.0 S2 Block w/new Mahle 104.5/Andial; rough bored - needs honing for final clearance 2200
968 Piston Squirters - new 100 SOLD
3.0 968 Crank Magnefluxed / Nitrided Std./ Std. 1000 SOLD
Pauter rods w/ custom undersized Clevite 77 Bearings - new 850
2.7 head, disassembled, cleaned, inspected 600 SOLD
Intercoolers - stock 75
951 intake manifolds 50
S2 front pully / harmonic dampener 65 SOLD
8R oil pans 50 SOLD
I.J. windage tray 3.0L , custom fitted - new 300
Camshaft - custom grind turbo - inquire 200 SOLD
Lindsey Super 61 turbo with #10 hotside / Dry 850
Balance shaft delete - Under Pressure Performance - new 175 SOLD
A/C Delete/Custom alternator bracket with 6lb. race alternator 350
Bosch high volume fuel pump 100 SOLD
Tial 38MM wastegate - ready to bolt on, atmosphere dump 250 SOLD
Lindsey 2 pc. Crossover / V-band 225 SOLD
LR solid engine mount 125 SOLD
Adjustable fuel pressure regulator - stock mount 80 SOLD
Clewett 8V ignition wires, new 50

Suspension:
Rear Koni dbl. adjustable coilovers 900
700lb springs for above 65
Front Koni Dbl. Adjustable struts - dyno tested good 1150
Rear Torsion tube w/ T-bar delete, Racers Edge inner and outer Delrin Bushings with grease fittings 175
Tarett Engineering front sway bar - Mod for steel A-arm 500
Tarett Engineering rear sway bar 400
Lindsey 3 pc. crossmember 250 SOLD
Manual steering rack W/ inter. shaft, new late offset tie rods & boots 375 SOLD

Transmission/Misc:
Turbo S 5-spd w/79K miles 1850
Solid Kokeln transmission mount 125
Sunroof manual latches 50 SOLD
Right side safety net and window net w/ release hardware 200
Sparco sport 2000 race seat 350 SOLD
Sparco aluminum seat mount - new 75 SOLD
Cool Suit box / pump / mount 250
Sparco 260 Quick Release Steering wheel w/ Hub 265

Body
968 '92 no hit tub w/ fenders, bumpers, side skirts; clean title 750 SOLD
968RS manual door mirror kit, new in box 450 SOLD
8 point custom fabricated weld in cage - 250 SOLD
Oil Coolers - Factory right and left for 968 - 350
968RS Intercooler ducts [exit + hood] - molded from factory originals - Offer

Dwane

Cross over, cross member and steering rack sold to me!
Thanks John

Dwane

TurboS Geek

PM Sent

968tcab

do you have cab top seals?

vette951s

Yes! Let me know which ones you need by referencing the factory part #'s. PM me your email address if you want pics.

John

kab996

Do you still have the plug wires?

vette951s

Yes I do. One plug wire in the set has a missmatched boot as there was a minor engine fire at new engine start up that singed only that one wire.

kab996

OK. Would you take $40 for them?

docwyte

Is the rear end you're selling with all the bushings etc assembled?

vette951s

PM sent

vette951s

I've been talked into parting it out so all I have left are the Lower Mount Tube Bushings (Racers Edge Solid $65) and the Torsion Tube with torsion bar delete and Racers Edge inner and outer Delrin Bushings with grease fittings (make offer). John