View Poll Results: what should i do?
swap in different crossover
3
42.86%
pull engine
4
57.14%
Voters: 7. You may not vote on this poll
i HATE 951 stock exhaust
10-14-2012, 03:39 PM
#1
Three Wheelin'
Thread Starter
i HATE 951 stock exhaust
for the past month or two my car had a tick when warm. i figured it was an exhaust leak but i swapped out lifters and injectors to hope it was one of the two. nope... cracked crossover pipe 
debating on rather to put in a different crossover pipe or to pull the engine. its getting pretty cold here in colorado and my car doesnt have a heater so im leaning towards pulling the engine to build it up for my pikes peak build.
debating on rather to put in a different crossover pipe or to pull the engine. its getting pretty cold here in colorado and my car doesnt have a heater so im leaning towards pulling the engine to build it up for my pikes peak build.
10-14-2012, 04:21 PM
#4
Three Wheelin'
Thread Starter
yeah i agree. i already have it off, only took me about an hour.
pulling the engine
about 2 hours
coolant hoses
wiring harness
engine mounts
bell housing bolts on tt
replace crossover
about 1 hour
bolt up a spare crossover i have
if i put in another crossover pipe, im just going to be doing repeat labor when it comes to pulling the engine in a month. like you said the crossover isnt to bad.
i have an audi that i bought for 400 and did a clutch on it. drove it for a few weeks and parked it. i let my brother drive it when his car was down and he was drinking and driving and hit a curb.
it needs a tie rod and 1 rim is bent... seat heaters, heater and a radio sounds real nice right about now lol.
ill wait to see what the poll ends up being
pulling the engine
about 2 hours
coolant hoses
wiring harness
engine mounts
bell housing bolts on tt
replace crossover
about 1 hour
bolt up a spare crossover i have
if i put in another crossover pipe, im just going to be doing repeat labor when it comes to pulling the engine in a month. like you said the crossover isnt to bad.
i have an audi that i bought for 400 and did a clutch on it. drove it for a few weeks and parked it. i let my brother drive it when his car was down and he was drinking and driving and hit a curb.
it needs a tie rod and 1 rim is bent... seat heaters, heater and a radio sounds real nice right about now lol.ill wait to see what the poll ends up being
10-14-2012, 06:52 PM
#6
yeah i agree. i already have it off, only took me about an hour.
pulling the engine
about 2 hours
coolant hoses
wiring harness
engine mounts
bell housing bolts on tt
replace crossover
about 1 hour
bolt up a spare crossover i have
if i put in another crossover pipe, im just going to be doing repeat labor when it comes to pulling the engine in a month. like you said the crossover isnt to bad.
i have an audi that i bought for 400 and did a clutch on it. drove it for a few weeks and parked it. i let my brother drive it when his car was down and he was drinking and driving and hit a curb. it needs a tie rod and 1 rim is bent... seat heaters, heater and a radio sounds real nice right about now lol.
ill wait to see what the poll ends up being
pulling the engine
about 2 hours
coolant hoses
wiring harness
engine mounts
bell housing bolts on tt
replace crossover
about 1 hour
bolt up a spare crossover i have
if i put in another crossover pipe, im just going to be doing repeat labor when it comes to pulling the engine in a month. like you said the crossover isnt to bad.
i have an audi that i bought for 400 and did a clutch on it. drove it for a few weeks and parked it. i let my brother drive it when his car was down and he was drinking and driving and hit a curb.
it needs a tie rod and 1 rim is bent... seat heaters, heater and a radio sounds real nice right about now lol.ill wait to see what the poll ends up being
10-14-2012, 06:56 PM
#7
Three Wheelin'
Thread Starter