Crazy Eddie

Hey Guys
Does anyone know for sure where this tab ( wire holder ) on the LBS cover is supposed to go
The Picture below is from Jon's (Techno Duck) write up I also have another from John Wood that show the wire hold tab on another bolt
Does anyone know for sure ??
Sorry for the nit picky question but what's an OCBD guy supposed to do
Thanks in advance
Ed

gruhsy

Now thats funny Eddie I always wondered where that left over part went

Gotta wait until I get my 4 post lift to put that back in. As to which location I don't know

Crazy Eddie

Thanks Jason
Maybe someone can chime in that has there car up or knows ...

facboy

Is it in PET? Seems to show everything.

Crazy Eddie

It doesn't show it under the engine section. PET weird that way.....
They will have the BS cover plate with the bolts but but the electronic sending wire is probably in some other place in PET ???

Crazy Eddie

Anybody ???
Thanks
Ed

Techno Duck

Ed, that is where it was on my car prior to disassembling everything. The lower balance shaft was never touched before i did it so i assume that is where it was when it left the factory but i cant say for sure.

Crazy Eddie

Thanks Jon
I have this picture from John Wood but I am a little unsure as to whether its upside down of not It looks like its in the same general area but the tab seems to be facing in the opposite direction ??
I will just try it and see I just seal the LBS with 574 so I didn't want to screw around ( no pun intended) with loosening the bolts
Here is the other picture