951S PMR Spec Race Camshaft - Que?
#16
Professional Hoon
Rennlist Member
Rennlist Member
Join Date: Jan 2010
Location: Melbourne, Australia
Posts: 7,090
Likes: 0
Received 4 Likes
on
4 Posts
Updated first post.
Duration: 256 degrees
Lift: .470"
Lobe center: Stock
Exhaust is full 3'' Fabspeed with high flow cat (also have straight pipe I could put on). Exhaust manifold is stock I believe? Unless that is part of a full exhaust, I would have to look, I do not know what stock is supposed to look like.
Duration: 256 degrees
Lift: .470"
Lobe center: Stock
Exhaust is full 3'' Fabspeed with high flow cat (also have straight pipe I could put on). Exhaust manifold is stock I believe? Unless that is part of a full exhaust, I would have to look, I do not know what stock is supposed to look like.
#17
Burning Brakes
Thread Starter
Join Date: Nov 2007
Location: West Chester, PA / Morristown, NJ
Posts: 1,242
Likes: 0
Received 3 Likes
on
3 Posts
Thanks Josh. Paulyy, I emailed again and requested the exhaust spec too. Thank you.
*edit*
They are saying that most of the cams for 944 they provide have the same intake and exhaust spec... I am trying to pin it down but PMR should have been the one to record this...
*edit*
They are saying that most of the cams for 944 they provide have the same intake and exhaust spec... I am trying to pin it down but PMR should have been the one to record this...
Last edited by Ben951S; 10-05-2011 at 12:34 PM.