can i ditch my power sunroof on 944 and fit manual one from 924?
#1
Pro
Thread Starter
Join Date: Dec 2010
Location: Canada
Posts: 572
Likes: 0
Received 0 Likes
on
0 Posts
can i ditch my power sunroof on 944 and fit manual one from 924?
87 951 I have. roof does not work. and to be honest I don't care for it. I want to instead add a manual roof from 924 if its the same fitment..
any thoughts would be great
any thoughts would be great
#3
I have plenty of experience... yes, fits and works fine. In fact, I prefer the manual set up over then electric version, its lighter, troublefree and works as well.
#4
Addict
Rennlist Member
Rennlist Member
I've been running that way for several years. You just need to manual latches, remove the lifting arms and off you go. You'll never look back.
Last edited by gregeast; 12-12-2010 at 01:10 PM.
#5
Pro
Thread Starter
Join Date: Dec 2010
Location: Canada
Posts: 572
Likes: 0
Received 0 Likes
on
0 Posts
I was doing some reading and some say the electric lid needs to be raplace with a manual one due to some bracket on it..
I am trying to make a check list of what to get.
I know of some 924 cars and some early 944 I was to see if I can get all I need
ps where the motor for the sunroof? I noticed in the back left corner behind carpet there is some kind of motor there but not sure what it is
I am trying to make a check list of what to get.
I know of some 924 cars and some early 944 I was to see if I can get all I need
ps where the motor for the sunroof? I noticed in the back left corner behind carpet there is some kind of motor there but not sure what it is
#6
Race Car
http://www.sidv.org/manualsunroof.htm
This should help.
And you do not loose the tilt feature, the black handles will sit in the groove around the roof.
You also do not need to strip the sunroof panel like he did.
This should help.
And you do not loose the tilt feature, the black handles will sit in the groove around the roof.
You also do not need to strip the sunroof panel like he did.
Trending Topics
#10
Race Car
You may have to notch the panel. Ill put some pics up when I get home.
Here this area may need to be notched to get the lever to go all the way down.
Here this area may need to be notched to get the lever to go all the way down.
Last edited by Dougs951; 12-12-2010 at 07:00 PM.
#11
Burning Brakes
I disagree...I love the electric tilt on my 944's over my 924T's manual setup. It's nice to just crack it a little bit on the freeway to circulate the air as it's a lot quieter to do so than opening a window. I usually leave it open just a tad on nice days to keep the interior temps down, too.
Granted, I've never had a problem with mine, so that miiiight change my point of view a touch, but...
#15
Hey Man
Rennlist Member
Rennlist Member
FYI. If you want to use a manual inner liner to avoid cutting the liner support you have to also use the outer fiberglass section from a manual SR model and match the color. The liners will not swap between the two sunroof versions due to a reinforcement bar installed on the electric model. I have never had to cut the pressboard liner under the vinyl to get the manual latches to seal and work perfectly. If you or anyone else can rotate their necks far enough to notice the latches aren't perfectly flat then you need to buy a 250 GTO Ferrari and go to the Pebble Beach Concours d’Elegance shows where the women wear wide brimmed hats and sip martinis.