FS: Guru 18psi Chip, Alpine Covers, Headlight assembly, Greddy Type S, and more!
#1
Rennlist Member
Thread Starter
FS: Guru 18psi Chip, Alpine Covers, Headlight assembly, Greddy Type S, and more!
Guru 18psi 24pin DME Chip
$50 shipped
Alpine White 951 headlight covers (have been resprayed at some point in time). Good condition. Two small imperfections shown in pics.
$45 shipped
Passenger side:
Driver side:
Headlight motor, assembly, lights, etc. (basically everything besides the covers) Good condition
$60 + shipping
OEM 951 motor mounts in great shape. No tears, leaks, etc. Felt just fine while in the car with no shaking, rattles, etc. Replaced with semi-solid while I had the oil pan off.
$45 shipped
Upper belt cover in great condition.
$25 shipped
Washer fluid reservoir. No leaks. Bottom tab has been cut and can be seen in the picture.
$20 + shipping
Genuine Greddy Type S BOV. Cap was powdercoated black chrome, but has some discoloration due to some moisture in the air compressor lines. Will include 1" inlet adapter that will allow you to use this with the stock IC piping. You will just need to get a 1.25" to 1" silicon reducer to recirculate back to the j-pipe.
$125 shipped
OEM downpipe in good condition and all 3 studs in place.
$25 shipped
$50 shipped
Alpine White 951 headlight covers (have been resprayed at some point in time). Good condition. Two small imperfections shown in pics.
$45 shipped
Passenger side:
Driver side:
Headlight motor, assembly, lights, etc. (basically everything besides the covers) Good condition
$60 + shipping
OEM 951 motor mounts in great shape. No tears, leaks, etc. Felt just fine while in the car with no shaking, rattles, etc. Replaced with semi-solid while I had the oil pan off.
$45 shipped
Upper belt cover in great condition.
$25 shipped
Washer fluid reservoir. No leaks. Bottom tab has been cut and can be seen in the picture.
$20 + shipping
Genuine Greddy Type S BOV. Cap was powdercoated black chrome, but has some discoloration due to some moisture in the air compressor lines. Will include 1" inlet adapter that will allow you to use this with the stock IC piping. You will just need to get a 1.25" to 1" silicon reducer to recirculate back to the j-pipe.
$125 shipped
OEM downpipe in good condition and all 3 studs in place.
$25 shipped
Last edited by alxdgr8; 04-25-2010 at 07:40 PM.