When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Just like it says....I need a good condition skid plate in the worst way AND in a hurry. This is the one to the rear of the motor/bell housing. I would also like to get the plastic one in front of this one. But the Aluminum one is critical.
Any help would be greatly appreciated. Money in hand.
I had them both but took off the aluminum one because it was such a pain in the *** to get it on and off. Obviously it was there to smooth things out underneath, but my guess is not many 951's have them on these days...
Will the aluminum one even stay on without the plastic skid? I was going to install the aluminum one the other day, but it looked like the leading edge of it has to attach to the skid to hold it up. Maybe I was looking at it - I didn't spend much time playing with it.
My 200K mile 4th owner 951 has all skid plates in place as well.... I added fender washers to keep it in place where it mounts in the wheel well in fact...