azmi951

I need the tube that bolts onto the crossover pipe. The little tiny one that everyone removes. Or I need about 1 foot of the cross over pipe side. I need this to take pressure readings of the exhaust so I can compare them to the intake pressure.

Thanks!

Cory9584

This would be a more permenent solution if you could get the proper gauge to read it. http://www.kavlico.com/pages/industr...lications2.htm (last one on the page)

samluke

I have one, and have tested for back pressure on the pipe. What result are you expecting to get?

I struggled to get any comparison numbers. It seems not many people have measured, or are not prepared to share.

Mine was up to 25psi @15psi boost.

TRP951

I run a a/n style fitting welded on my crossover a inch from the turbine housing, I have measured it at about 30psi at 22psi of boost

azmi951

Cory, that is a little more than I was looking for.

As for you other guys, that looks pretty good, all below 2:1. And Tim, WOW.