FS brake rotors, Carillo rods, cylinder head, airflow meter, intake
#1
Three Wheelin'
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
EDIT, EVERYTHING IS NOW FOR SALE FOR 75% of what I was asking, so 75% of the prices listed below!
I am cleaning out extra stuff from my basement, must sell all of it.
buyer pays shipping, I will ship when I receive payment. I have sold many parts to many rennlisters over the past few years and never had any complaints. Paypal works if you will pay the extra 5% (still 5%?)
These parts were stored without WD-40 sprayed on them properly for a while, so they have surface rust and look ugly, but no structural problems I am sorry about the low quality of pictures, my camera's flash is intermittent. If you are interested and need better pictures, say so.
2 NEW never used Zimmerman front rotors for 944S2, 944 Turbo 87-88, 968 (not M030)
New $182 Sell for $140
2 NEW never used Zimmerman rear rotors for 911 89-94 (964), 944S2, 944 Turbo 87-91, 968 New $156 Sell for $115
Pictures of these http://users.wpi.edu/~mark944/march%...otors%2087.JPG
2 barely used (less than .5mm of wear measured with caliper) front Zimmerman rotors for 86 944 turbo This set has more rust, but still would come off the first time you drive. They are not warped, etc, just rusty.
New $165 Sell for $90
2 barely used (same car as above) rear Zimmerman rotors for 928 86-95, 944 Turbo 86 New $186 Sell for $100. Also rusty
Pictures of this set didn't come out well, but you can see the rusty one in the left corner here, they look like that: http://users.wpi.edu/~mark944/march%...2/IMG_1132.jpg
1 set of 4 used carillo rods, stock length, balanced, ready to go. Came from a racecar, low miles but they are "used". I was planning to use them but never had time/lost interest. These have the newest style rod bolts (included) New $1016 Sell for $750. pic http://users.wpi.edu/~mark944/march%...2/IMG_1120.JPG
944 turbo cylinder head. 1 exhaust valve burned due to wastegate installed backwards (wasn't me). The rest of it is nice, clean it/replace 1 valve and it's ready
$230
http://users.wpi.edu/~mark944/march%...2/IMG_1119.JPG
Intake Manifold - no tps or idle screw
$60
Rebuilt turbo airflow meter - car ran great with this, has been opened before (can see blue silicon sealing it) leading me to say "rebuilt"
$50
944S2 AFM good working order, car ran etc
$70
Set of everything needed to replace front wheel bearings for 87+ 944 turbo (seals + inner and outer bearings for both sides)
$42.80 new, sell for $30
That's all for now
I think the prices are good, but I am just going to lower them if things don't sell in the next few days.
email mark944@wpi.edu
or post here
I am cleaning out extra stuff from my basement, must sell all of it.
buyer pays shipping, I will ship when I receive payment. I have sold many parts to many rennlisters over the past few years and never had any complaints. Paypal works if you will pay the extra 5% (still 5%?)
These parts were stored without WD-40 sprayed on them properly for a while, so they have surface rust and look ugly, but no structural problems I am sorry about the low quality of pictures, my camera's flash is intermittent. If you are interested and need better pictures, say so.
2 NEW never used Zimmerman front rotors for 944S2, 944 Turbo 87-88, 968 (not M030)
New $182 Sell for $140
2 NEW never used Zimmerman rear rotors for 911 89-94 (964), 944S2, 944 Turbo 87-91, 968 New $156 Sell for $115
Pictures of these http://users.wpi.edu/~mark944/march%...otors%2087.JPG
2 barely used (less than .5mm of wear measured with caliper) front Zimmerman rotors for 86 944 turbo This set has more rust, but still would come off the first time you drive. They are not warped, etc, just rusty.
New $165 Sell for $90
2 barely used (same car as above) rear Zimmerman rotors for 928 86-95, 944 Turbo 86 New $186 Sell for $100. Also rusty
Pictures of this set didn't come out well, but you can see the rusty one in the left corner here, they look like that: http://users.wpi.edu/~mark944/march%...2/IMG_1132.jpg
1 set of 4 used carillo rods, stock length, balanced, ready to go. Came from a racecar, low miles but they are "used". I was planning to use them but never had time/lost interest. These have the newest style rod bolts (included) New $1016 Sell for $750. pic http://users.wpi.edu/~mark944/march%...2/IMG_1120.JPG
944 turbo cylinder head. 1 exhaust valve burned due to wastegate installed backwards (wasn't me). The rest of it is nice, clean it/replace 1 valve and it's ready
$230
http://users.wpi.edu/~mark944/march%...2/IMG_1119.JPG
Intake Manifold - no tps or idle screw
$60
Rebuilt turbo airflow meter - car ran great with this, has been opened before (can see blue silicon sealing it) leading me to say "rebuilt"
$50
944S2 AFM good working order, car ran etc
$70
Set of everything needed to replace front wheel bearings for 87+ 944 turbo (seals + inner and outer bearings for both sides)
$42.80 new, sell for $30
That's all for now
I think the prices are good, but I am just going to lower them if things don't sell in the next few days.
email mark944@wpi.edu
or post here
Last edited by mark944turbo; 03-21-2008 at 06:24 PM.
Trending Topics
#11
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
[B] buyer pays shipping, I will ship when I receive payment. I have sold many parts to many rennlisters over the past few years and never had any complaints. Paypal works if you will pay the extra 5% (still 5%?)
email mark944@wpi.edu
or post here
email mark944@wpi.edu
or post here
#14
Three Wheelin'
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
I didnt know that wasn't allowed. Strange.
Anyway, thanks Jim, I'm glad you are happy.
The cylinder head and AFM's are still available, everything else is gone.
Anyway, thanks Jim, I'm glad you are happy.
The cylinder head and AFM's are still available, everything else is gone.