jlturpin

No chip needed, but will be fine.
As stated, more parts needed. I need one for an extra, just incase the ECU is bad once I get the car back together. There were some flaky things going on with several things and there were some wires in the harness that looked pretty bad.

88951er

Jonathan,

Not to put too fine a point on it, what would the DME be worth to you? If I were independently wealthy, I'd gladly give one away but sadly that's not the case.

Doug

samluke

I have a couple of sets of TurboS DME's and KLR's. PM sent

jlturpin

PM Replied. I don't want to pay a fortune for it. The car ran, but had some wiring harness damage. The 12V switched port at the diagnostic port showed 12V with my meter, but would drop to 1-2 V when load was applied. That is the main reason I think I may have problems with DME.

I just need a DME, I have the chip I need. Thanks

jlturpin

The part number for the DME is 951.618.121.09 followed by TYP 951 MW-02 the Bosh number is 0 261 200 088.