NZ951

Should be here next week... cant wait. I will write up how it goes, will be used with the Link LEM and Link AF gauge.

daniel951

i ordered mine too Andrew. Of course u will receive it before me since u are over there. Let me know how it goes on connecting everything.

NZ951

Well its a bit different, its a test 2CO unit... much better with the standalone...

special tool

Probably going to pick up 50 hp with that thing. They are great.

NZ951

Yeah I so cant wait...

I have a few too many controller and boxes now, I think I will have to make a panel to mount them...

Link ECU, Link H20 controller, Link Knock Bloxk and now Tech Edge WB unit.

Mike S

I've got an older version 1.5 unit that I love. Great easy to read display. The software that was availalbe was rather limited, but other than that it worked perfectly right out of the box. The other down side to my unit is that I had to use the L1H1 sensor at $150 each, where you guys should be able to use the $50 variety.

NZ951

Yeah the unit I am testing uses a Bosch 7057 unit... its cheaper than the NA unit I bought when I rooted it with av gas.

hally

I'm using the 7057 with the 2B0 its been great with no dramas. I like the logging software also. As well as graphing capabilities, you can matrix up variables of your choosing (in configurable increments) in a tabular format and collate, min, max, average, #samples in each cell.

daniel951

i don't understand everything u guys are saying LOL. all i know is i ordered the techedge wideband and o2 sensor.

hally

when i first fired up the software (version 2c from memory i think its up to now), the graphing looked a mess until i worked out that it was displaying an entire 30minute log run on 1 screen and that you could recursively zoom in on an area of interest to get the desired resolution.