86 951 with a spun rod bearing on cylender #1 and 135k miles on it
name your parts you want with the price your willing to pay for the part. if there is enough people wanting parts then ill part out, the cars apart now.
everything was in good condition til the rod bearing failure ill get some pics up later if there is intrest


I would like the rolling chassie gone as whole and wont sell anything else until the car is gone

the car is rolling right now so the front suspension and steering is on and is ready for immediat pickup

the leather seats have tears in them im not sure if there was a picture of them or not but i can get picks of everything and anything from all angles

email me at turbo8@hotmail.com

car is in las vegas,NV 89123

 

J-boot (including the hoses that go to it) - $30
Cycle valve - $25
Plastic plates / running boards near jack points - $20
A/C - heater control panel & buttons - $30
Plastic intercooler scoop - $20
Wastegate, cat pipe, & down pipe - $100
Crossmember - $100

Probably some others too. . .

 

If you have a gauge pod I'd be interested in that.

 

ok if the list goes over $4k ill part out, if not ill rebuild the engine and keep it
so far $325
also have momo steering wheel
reliboost thingy
some authority chips
gutted cat
flowmaster muffler
3subs in the back,6cd changer in glove box, and a alpine head
some sort of wheels ill fine a link to the wheels i have somewhere around this site

 

whats the gauge pod your refering too?

 

I'm not aware of the market prices for some of these, so no flames if I'm way off.

Shift knowb/boot - $20
Wheels (depends on type/weight 16 inch preferrable) - ??
Driver's side jacking point (if this is not welded) - $20
luggage compartment cover - $20
Momo horn **** - $5
Seat rails -$25
Ashtray - $5

 

https://rennlist.com/forums/944-turbo-and-turbo-s-forum/147698-what-kind-of-wheels.html
theres a pic of the wheels and the car

 

pics

 

An a-pillar gauge pod?
http://www.gaugepods.com/944_2.jpg


Also, what type of subs do you have?

 

no sorry dont a a piller gauge pod

 

also i have new in box stuff..
renbay a\f gauge
4 rad hoses
timing belt
distributer cap
lindsey racing vacum line kit with the 5 brass t fittings, the vetur tube delet kit
and a rod bearing set

 

Where is the car located? And what do you feel the rolling chassis is worth? (no motor, no trans, no interior would be ok) Any rust?

 

cyl. head= 300.00
front bumper cover=80.00
under trays(2 pieces after bat wing)=40.00
alternator cooling assy.=25.00
idle control valve=15.00
pm me if you think i should make a better offer. i pay shipping of course

 

the car is in las vegas nevada, the rolling chassi is in great condition. im not sure but i think the car has an lsd in the read. before the failure the car was solid as a rock and felt normal driving 150mph

 

LSD, how much?