Need Engine!
05-18-2004, 12:37 AM
#1
7th Gear
Thread Starter
Join Date: Nov 2003
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Need Engine!
I've been looking for an engine for my '86 Turbo for some time now and havent really had any luck, so I'm turning back to you guys again for some help. I would like to have something with low mileage, but at this point I'll take anything that breaths. My boost fever has reached its boiling point and i think im goin to explode.
Any info would help greatly, no matter what part of the country it comes from. I'll pay shipping because the cheapest I could pick one up for is $2600. I thank you for any help.
Any info would help greatly, no matter what part of the country it comes from. I'll pay shipping because the cheapest I could pick one up for is $2600. I thank you for any help.
05-18-2004, 12:47 AM
#2
Addict
Rennlist Member
Rennlist
Site Sponsor
Rennlist Member
Rennlist
Site Sponsor
I have a freshly rebuilt (0-hours) "Blue Printed" long block. Many mods done to the block to make it live longer.. Everything was replaced!! so it's basically a new engine. Email me directly if interested.
05-18-2004, 01:06 PM
#4
Three Wheelin'
I have a 126k mile one, but it has good compression. I think around 140 plus or minus 5 for all cylinders. New rod bearings, does not include airbox, waterpump, or timing/balance belts.
Located in Mass, still in car, but I could have it out in a few weeks if you are in a rush.
1500 for it-- the catch is the time you may have to wait for me to remove it.
Located in Mass, still in car, but I could have it out in a few weeks if you are in a rush.
1500 for it-- the catch is the time you may have to wait for me to remove it.
05-18-2004, 02:14 PM
#6
Race Director
I'm looking for 944 and 951 short-blocks that are in need of rebuilds. Stuff excessive damage to the bores that can't repaired by simple overboring & honing are particularly welcomed. 