KLR

Can someone please measure for me the distance between the right side tail light and the bottom of the 'urbo' and then the distance between the 'o' and the seam between the quarterpanel and the rear panel?

My badge is currently misplaced and I'd like to right it.

Thanks!

- Neal

KLR

Bump... I'd be forever indebted if someone would grab a tape measure and post the result. My Turbo badge is, inexplicably, placed on the wrong side and slightly crooked. Please help me right this injustice -- I'm afraid that God will kill yet another kitten if this doesn't get fixed soon.

W88951

Would love to help, but I took mine off.

Laust Pedersen

I just guestimated the placement based on pictures and probably gave it a little more thought than the factory by placing it closer to the center, so the drain hole from the hatch does not fill the badge with ugly junk.

Laust

dmoffitt

i'll see if i can't measure it tomorrow IF i go over to the paint shop and IF they haven't removed it yet...

JoeN951

neil, my "o" is 1/2" from the seam to the right of it and 1-1/2" above the crease in the sheet metal below...

hope this helps

Asarus

If that can help...

Sorry no measurement because the car is not at home currently


Stock paint, and stock Turbo placement

nickhance

Asarus:
Do you have any side pictures of your car? I'm not sure if I like the 968 wing or not on the apline cars.

Asarus

Sorry Nick, i have no other pictures currently. I'll have to wait for the car to be at home to make some others (in a few months).

As far as i'm concerned, i like this wing. And anyway, this is the stock wing for 1990 & 1991 951 ;-)

Mine will be alpine white (as the car), as soon as i get my car back

dmoffitt

I'm going over to the shop again this morning in about an hour and a half and am bringing a digital camera and my tape-measure, hopefully the badge is still on the car

KLR

You guys rock! Thanks for the help.

Luis de Prat

Waterguy

2 5/8"
1"
Bottom of the 'urbo' to the crease in the metal below it: 1 1/2", like Joe says. That puts the top of the 't' and 'b' about 1 5/8" below the crease in the metal above it.

Silverbullet951

I guess that answers it..

dmoffitt

thx waterguy, they'd already removed mine the other day, good thing too, cuz some MORON at the paint-shop delivering tires RAN INTO MY G-D CAR with his truck, right to the left of where the badge used to be.... thank god it was the only sheet-metal part of the car left (besides the roof) and didn't destroy the fiberglass rear quarter..... UGH. oh well at least now i'll know when it comes time to put mine back on that they'v done it right from these #s