jedi951

Hi guys! well finally got to remove the bell housing and I found that my release fork had broken, not all the way but it had a crack 2mm wide that gave it a 1/2 inch difference in level compared to the unbroken leg. Those of you that have seen one prbably know what I mean. The symptoms that brought me to tear it down (the clutch job) were difficulty shifting all of a sudden. Was able to drive a few more days than one morning I tried to put it in gear and it was like if I was just trying to shift without pressing the clutch pedal. I hope this comes in handy foe someone some day. On another note...WHERE WOULD BE A GOOD PLACE TO FIND A FORK AND DO THEY COME WITH BEARINGS? THANKS ..

jedi951

Also, how much do they run for? I've been trying to find something on-line but so far I got nothing..thanx

BoostGuy951

You will probably have to find a used one from someone with a parts car.

Premier Motorsp

I have a used one. Email Technodyne@earthlink.net

Chris Cervelli

cruise98

Get new bearings and a shaft while you are at it. Chris probably has those too.