Reference sensor sleeve dimensions
#1
Pro
Thread Starter
Reference sensor sleeve dimensions
I'm looking for possibility to modify my early style ref sensor bracket to accept the sleeve for reference mark sensor. It looks like my car has had the bracket replaced down the road with the old style one. Price for the new sleeve is a bit high, I'm working with highly skilled machinist who can make it for free... I will appreciate if someone who has it spare or just available/accessible give me the dimensions - OD, ID and total length. I presume it is made of aluminum? I would just measure the spare sensor to figure it out but I'm away from home so your help would be much appreciated. TIA!
#4
Rennlist Member
Hard to get a consistent reading, but I'd say 15mm even is probably most accurate for the I.D. for the bracket I have -- no taper that I can detect. The sensor itself has an outside diameter of about 14.9mm.
Here's the overall length of 54.8. Note that there is a little lip on the top side that is about 2.2mm tall and has an O.D. of 19.5mm. The O.D. of the body itself is about 18mm. The lip on top acts as a stop to seat it in the bracket. A magnet does not stick to the sleeve and it appears to be aluminum. Note also there is a bevel on the I.D. of the top lip, presumably to help center the sensor and guide it in place. There's also a bevel on the O.D. at the bottom.
#7
Pro
Thread Starter
Just on a side note regarding the material it will be made of. If I cannot find suitable piece of aluminum - will stainless steel work? I'm not an expert when it comes to magnetic fields, interference etc. What do you think?
Trending Topics
#8
Race Car
#9
Pro
Thread Starter
Around $0.50 an inch.
BTW thank's for the drawing!
#10
Addict
Lifetime Rennlist
Member
Lifetime Rennlist
Member
Join Date: May 2001
Location: Hotlanta - NE of the Perimeter
Posts: 12,269
Received 266 Likes
on
153 Posts
Stainless has ultra low magnetic properties due primarily to the Nickel and Chromium content - essentially none. Depending on clearances between the sensor and the sleeve - more of a potential of galling. Use a light coat of nickel based lubricant during assembly and you should be fine.
#11
Rennlist Member
I'm far from an expert (far), but I assume the factory used aluminum because it is highly conductive and therefore a good shield for electromagnetic noise. Aluminum is up there with silver, gold and copper in terms of conductivity, whereas most stainless is near the bottom of the list in terms of conductive metals. See chart linked below. That said, aluminum is all around us -- surely you can find an old bike handle or something that can be machined into a tube...
http://www.tibtech.com/conductivity.php
http://www.tibtech.com/conductivity.php
#12
Pro
Thread Starter
Thank you very much for your assistance here. All is clear - it has to be aluminum or copper. Unfortunately at the moment I have stainless steel and brass only available but I may be able to find a nice piece of copper.