Hymodyne

greetings,

I'm putting my k-jet fuel system back together and I am a victim of my own imprecise pictures at teardown. I took pictures of the banjo bolts and lines at the distributor, but none follow the lines to their injectors. I preserved the bends in the lines as best I could while cleaning, but some may be reversed at the distributor. The pet diagram is pretty good, but does not clearly show routing.

James

Rob Edwards

Not sure if this is close enough to final positions to be helpful, but maybe?



At Fuel distributor:

Hymodyne

thanks!!

hlee96

Thanks for the question and answer!
Pics for the archive when I put the lines together.
My retinas are burnt from the shiny pieces.

-hoi

karl ruiter

Its actually kinda simple: they go in reverse order. Unlike plug wires that can be a little hard to figure out.

Dave928S

Here are pics from when I stripped my motor from all angles .... not clean or shiny Some lines moved slightly out of alignment, and all clips not in place.

Hymodyne

excellent pictures, wonderful assistance on this site.

kiwiokie

Funny I just did the same thing. Was sure I would be able to get them back in the same order. If I am looking at the pictures right the order is:

.1(---)5
2(-----)6
3(-----)7
.4(---)8