Houston928

Looking for a little help, can anyone tell what this connector is and where it should connect to. It's located under the air cleaner box at the rear of the motor. Thanks.

PorKen

Archaic workshop diagnostic hookup. Goes to a TDC sensor on bell housing.

Houston928

Thank you.

brycycles

Yes, thank you! Been staring at it too

bureau13

Mine...thinking it's the same thing...is hanging down and laying against my headers, causing an occasional whiff of burnt plastic smell. I tried to stuff it somewhere but it fell down again.

What happens if any of those wires get shorted out? Hmmm...

davek9

Nothing, just remove the non powered sensor from the top of the bell housing

soontobered84

IIRC, it's supposed to bolt to the back of the driver's side (Left side) fuel rail.

davek9

Nope, right when the OP pic shows it on the intake