dr bob

I was trying not to miff the ^short guys...

bran3b

well crud!!! Now I have no signal to the injectors at all. Back to the drawing board.

Mrmerlin

did you cut off the small black collar around the connector at the distributor?
The new green wire has this black collar and it needs to be removed prior to installing the connector into the distributor

bran3b

I did. First thing that I am going to do is pull the distributor back apart and make sure that I got everything back right. The voice in my head says that I missed the plug somehow.

IcemanG17

I am LUCKY that my non stock ignition system bypasses this part.....

bran3b

ok, I have a signal back but same as before, EXTREMELY dim light when using a noid light. It was probably there earlier but just so dim that I didn't see it. Next I am going to move on to grounds, this now feels like a bad ground for the injection system, but I am open to suggestions too, I am new to EFI so learning as I go. Since I have ruled out the green wire, I am going to go back to my original thread at https://rennlist.com/forums/928-foru...l#post10695428. Thanks for all the help.

Mrmerlin

there are two grounds on the right cam tower look carefully these need to be removed and cleaned then refitted

NOTE do this first before any more testing

bran3b

MrMerlin, Will go for these first, thanks for the tip.