ledee416

all come from inside center console. I assume some are for blower motor and some are for radio, but I simply do not know which is which. a few have power.

Instead of looking at a schematic for hours, I figured I would ask the experts. I will refer to them by numbers so answers will be less confusing

1) this one has heavy gauge wires:



2)

3)

4)

5)

6) all three of the above are out of the same harness:


7)

8) http://i298.photobucket.com/albums/m...1-07172546.jpg

Lizard928

#1
rear wiper switch, its male counterpart is sitting on the left in the picture.

#2, and #3 are for the central locking/AC/warning cancel that sits right below the HVAC.

James Bailey

Also called acknowledgement panel.......part of what went missing with the gauge "upgrade"

James Bailey

7 should be named Mickey as in mouse.....added on for ?????

ledee416

I suspected 7 was aftermarkert. no clue what it is attached to.

ledee416

any idea about 4 and 5? 5 has power to one of the two leads when key is in acc postion

ebay has a dasj indicator with reset switch that has the same 2 lead and same color.. so i guess that is what its for.

ledee416

so the male counterpart on left should be plugged into the female #1? where would / is the rear wiper switch ?


so none of these connectors are supposed to be hooked up to the blower motor? I believe the blower motor is still in the car, although I am not sure. I assume it is integrated to the black plastic vent box that is in back of center console area.

ledee416

lol @ upgrade... so true... sunpro makes about the worst gauges known to man. they are mechanical too. so if i acquire one of these panels i should be able to plug those connectors in?

ledee416

anyone know what the heck #4 is for? in pic 6 you can see that all 3 of those connectors originate from basically the same area of the harness.

ledee416

blower motor no?

ledee416

I was able to get a reset button / warning system panel on ebay today. It happens to have the same exact blue and white 2 wire connector match as the one under my console, so I assume it will work.
http://www.ebay.com/itm/400336719349...84.m1497.l2649

it does not however have a power lock button on it, and it appears to only have one other 4 wire connector. I guess it will match up to one of the two in the picture above.

Can anyone else help me identify these other wire/ connectors? I believe I have confirmation that the connector I suspect is to the blower motor is in fact correct.

James Bailey

1980 cars do not have the lock button ....If you need to know what fits what go to 928 Internationals store and look at descriptions and part numbers as they are correct also give you an idea of values.

ledee416

that works out well then. I believe I bought the correct piece. it came out of an 82. I dont think that connector #1 was correctly identified. Lizard said its male counterpart was in the pic. As it turns out, that green connector is connected to the other half of it... I believe this would mean connector#1 is in fact not for rear wiper... what else could it be? As stated earlier, they are heavy gauge wires. What else coming from that area would use a connector like that with some thick wires? anyone know?

ledee416

here is the #1 connector that is still unidentified next to what I assume is the fully conected rear wiper connector: