Just a preview of an SC setup
#226
Addict
Rennlist Member
Rennlist Member
Thread Starter
Join Date: Feb 2004
Location: Monterey Peninsula, CA
Posts: 2,374
Likes: 0
Received 16 Likes
on
12 Posts
Originally Posted by Imo000
How about some pictures of any functioning piece then?
If you mean from the supercharger directly, I posted a twin injector runner that was 3D printed as well.
If you haven't seen the pictures, you can search earlier in the thread.
As before, one constraint in the decision process is whether or not to use newer super composite materials as they become less expensive compared to machining and or casting aluminum.
The good thing is that whenever I get time to focus on this again, I'm sure there may be even better material available than now. So, this decision will wait until I am ready to continue.
Anyway, hope your question was answered.
#228
Addict
Rennlist Member
Rennlist Member
Thread Starter
Join Date: Feb 2004
Location: Monterey Peninsula, CA
Posts: 2,374
Likes: 0
Received 16 Likes
on
12 Posts
Originally Posted by Imo000
Wait long enough and it will grow out of the ground by itself.
Besides, the deprivation of being relegated to the Ferraris is of course significant punishment I happily tolerate.
It's a hard cross to bear, but someone had to do it.