Rick,
Embree Machining is doing it for me. I am going ahead and get one done. Then I will post pixs and see if there is any interest in additional units or a group buy.

 

Any updates on this new pulley?

Dan
'91 928GT S/C 475hp/460lb.ft

 

It is done and should be "in the mail."

 

Please post pics when received.

 

There are pics here.

They aren't coated in these pics but have been balanced. I'll post pics when I receive mine.

 

OK, so I see you got a larger main crank pulley but kept the accessory area smaller so as to not overdrive them. Cool.

 

I just went along for the ride that Ralph set up.

 

Ok, so you went 10% bigger for the S/C portion. Is that the same as Ralph's? I thought his was going to be 6". Also, how much was it?

Dan
'91 928GT S/C 475hp/460lb.ft

 

Ralph's crank pulley is 6" and mine is 5.6", same size (5.125") for the accessories. Ralph also has a larger SC pulley. I don't remember the price only that is was quite a bit more than I originally thought it would be.

 

Rick,

Can you please post some pics? You have to be a member to view the pics on the link you posted.

 

Sorry, here it is.

 

Thanks Rick,

Were you able to use the pulley I sent you?

 

Hi Gio,
When I took it to a machine shop they made it into a paper weight.

 

That sucks. When I looked at your car at SITM your SC looked identical to mine so I thought it would be an easy fit.

 

I just received my pulley and it looks great! They did a fine sandblasting on it and then clear powder coat. Embree also added a steel bushing for the crank bolt washer to tighten against and a raised lip to prevent belts from walking off. They were also sent to a professional balancer so they should really work nicely. Hope to get mine on very soon. Will send pictures.