1980 Pressure Plate/Clutch Disc Problem
#61
Team Owner
Note the early bell had a different pivot point instead of a ball it was a pin so that would make this part fit easier
#62
Rennlist Member
Thread Starter
Amazing what having the correct bell housing will do.
#63
Team Owner
while your at it clean off the port for the timing sensor and JB weld a quarter over it this will reduce water ingress
#64
Rennlist Member
Thread Starter
#65
Rennlist Member
Thread Starter
Fixed. I used one of my aluminum plugs I use when I delete rub strips.
Last edited by Kevin in Atlanta; 08-23-2023 at 02:40 PM.