S4 upper radiator hold down
#17
@ReDesign by FEATHER : I don't know about others, and don't want to derail the thread but I, for one, am interested in the other riveting options.
Cheers
Cheers
__________________
ReDesign by FEATHER
by Jerry Feather
Producer for 928 of:
-Hatch Latch Receiver Liner--All Versions
-Replacement Heavy Duty Spare Tire Cover
-Flush Center Console Conversion
-Cowl Cover, Cowl Seal, & Shell Stickers--All versions
(RHD included)
-Aluminum Gas Cap Ratcheting Pawl
ReDesign by FEATHER
by Jerry Feather
Producer for 928 of:
-Hatch Latch Receiver Liner--All Versions
-Replacement Heavy Duty Spare Tire Cover
-Flush Center Console Conversion
-Cowl Cover, Cowl Seal, & Shell Stickers--All versions
(RHD included)
-Aluminum Gas Cap Ratcheting Pawl
The following users liked this post:
Zirconocene (05-21-2022)
#18
Have not had time to do this rIght-
meaning pulling the radiator to get any decent access to the area needing repair-
Was considering a make shift bracket using the fender bolt so I can drive it for now-
I think I would have to get a different rubber bumper-
Stock seems pressed in to the brackets.
Stand by for radiator removal!
meaning pulling the radiator to get any decent access to the area needing repair-
Was considering a make shift bracket using the fender bolt so I can drive it for now-
I think I would have to get a different rubber bumper-
Stock seems pressed in to the brackets.
Stand by for radiator removal!
Last edited by PC-85-928S; 05-31-2022 at 10:25 PM.
#19
Finally got to this repair-
broke out the quick jack I got for x-mas-
i drilled a new hole, and realized the other side of this bracket is really near the headlight-
With the headlight up, you can see where the gold screw comes out from underneath the car-(see pic)
I went with a nut and bolt.
I put the nut in the inside fender area, so it would not interfere with the headlight.
The only way to do this job properly is with radiator and fan removal.
(every time I remove the fans it’s like a wrestling match with me ending up bleeding- Hans please make more fan shrouds!)
broke out the quick jack I got for x-mas-
i drilled a new hole, and realized the other side of this bracket is really near the headlight-
With the headlight up, you can see where the gold screw comes out from underneath the car-(see pic)
I went with a nut and bolt.
I put the nut in the inside fender area, so it would not interfere with the headlight.
The only way to do this job properly is with radiator and fan removal.
(every time I remove the fans it’s like a wrestling match with me ending up bleeding- Hans please make more fan shrouds!)