John S. Markowitz

Hi All

Going through a bad patch w my car- one damn thing after another.

Any recommendations for an aftermarket radiator. It has the original Behr radiator in it that is now leaking and I am perfectly fine with any replacement that did as well as the original that lasted >25 years.

I do not seek the best radiator on the planet- just a solid stock replacement or similar.

Thanks in advance

John

1991 928S4
Automatic

NickTucker

I went thru a few Behr units until I gave up and went with a C&R all aluminum radiator. 928 International was selling it..

Never had a problem since and it's been over 10 years....

Chalkboss

CSF all aluminum radiator from 928 Int. Fine quality. Buy factory looking stickers from Roger and you're good to go.

SeanR

What they said. The CSF from 928 Intl or through Roger @928sRus.

John S. Markowitz

Thanks fellas
I'm not 25 miles out from a sheared-off torque tube repair and a new window controller module and now this. I suppose these cars are getting up there in car years!

As always- thanks for the input!

leiplouis79

Here is a Pic of the CSF in my car - got it from Roger -

ammonman

Where is your current Behr unit leaking? The usual issue is the PS plastic end tank right at the inlet nozzle. New tanks w/seals are available from the Big 3 and there is a great write-up on how to replace them here on the forum. I did both mine about 5 years ago and have not had any issues (and I daily drive my 928.) If your core is leaking then a new CFS from Mark/Roger would be the best route IMHO.

Mike

Live2Hover

Hey leiplous79 where did you get those cool looking air intake hoses? They look great!

Petza914

I've had the 928 Motorsports all aluminum radiator and expansion tank in my 928 Spyder for about 3 years now, no issues at all. Also have their push/pull fan setup and controller

John S. Markowitz

erday.

Hi Mike

Thanks for pointing that out, and I'm not positive, but that could be where the leak is- my mechanic just pressurized and looked at it yesterday-I will double check with him on this.

Would be nice to find out this was the issue

John

Koenig-Specials 928

I have the same for more than 5 years now. Also no issues

mdkelly1

+Another satisfied customer here for the CSF unit. Replaced the leaking Behr unit with the CSF radiator and it works great!

You can get the CSF unit from 928 International and 928sRus. In addition to the great cooling, new stickers from Roger made everything look new again.

Chalkboss

Here's what the CSF radiator looks like with reproduction stickers as I described above. I have the old Behr which has a leak in side tank sitting collecting dust- I just wanted a new fresh unit in there.

John S. Markowitz

Some beautiful engines there boys and girls!

hacker-pschorr

Which radiator did you end up going with?