Clear HVAC plate
#16
Racer
Thread Starter
#17
J1NX3D, I dug around for what I had left, but I suspect it was the victim of a "cleanup" of my workbench, as all I can find are the two round *****. It seems to always be the case that I'll hang on to something for ages, then finally get rid of it just before it's needed again.
#18
Pro
Making progress. Dimensions are very close now.
It'll never be crystal clear, but it does transmit light through it.
It's a bit stronger and less brittle than the original part.
I did some destructive testing on it, which is why it's missing some clips.
It'll never be crystal clear, but it does transmit light through it.
It's a bit stronger and less brittle than the original part.
I did some destructive testing on it, which is why it's missing some clips.
#20
Pro
The fan speed dial, slider graphic, and temp dial are stuck on the OE part, so it looks like I'll need to have stickers made up too.
Luckily I don't need a list - I can create these to match demand.
I hope to have these available in a couple weeks.
#23
Advanced
Was this a working head unit? It looks like all of your capacitors have leaked (the white goop). These too should be easy enough to to replace and clean up. Watch to polarity
#24
Pro
Yeah, it was working before I took it apart, so I suppose now would be a good time to replace those capacitors.
One more winter project.
#25
Pro
Making progress.
#28
Pro
#29
Pro
Making progress. Everything snaps and fits together properly.
This is a raw print - Everything fit without any use of a knife. Some 'blobs' are visible on the snap clips.
Should light up just fine. I'm using a flashlight awkwardly here, but the HVAC bulbs are more strategically placed.
Tomorrow I'll make sure it installs into the dash.
Next week I'll try to make/source stickers for the dials.
This is a raw print - Everything fit without any use of a knife. Some 'blobs' are visible on the snap clips.
Should light up just fine. I'm using a flashlight awkwardly here, but the HVAC bulbs are more strategically placed.
Tomorrow I'll make sure it installs into the dash.
Next week I'll try to make/source stickers for the dials.
#30
Burning Brakes
This really great!
Do you think that extra material could/should be added in the areas that the panel commonly cracks (usually around the switches at the opposite ends)?
Do you think that extra material could/should be added in the areas that the panel commonly cracks (usually around the switches at the opposite ends)?