FS: Bilstien Escort Cup, Dynatech, Camber and Strut Bar
07-17-2011, 10:13 PM
#1
Addict
Rennlist Member
Rennlist Member
Thread Starter
Join Date: May 2001
Location: Melbourne, Florida
Posts: 942
Likes: 0
Received 0 Likes
on
0 Posts
FS: Bilstien Escort Cup, Dynatech, Camber and Strut Bar
This is the suspension from my 86 Turbo I am parting. The shocks, struts, springs, camber plates and strut bar all have ~5k miles on them. The struts are the escort cup valving and I have the helper springs front and rear. The front springs are 400# and the rears are 550# The strut bar does have a couple of marks in it where it has rubbed the hood.
I would like to sell the complete setup, but I am willing to break it up if there are buyers for everything. If I end up breaking it up, I also have the front spring hats to use with other camber plates or factory front strut mounts.
I am asking $2000 for the struts, shock, springs, helpers, camber plates, and strut bar as a package plus shipping.
I also have a set of front control arms. The control arms are the early offset with the 968 M030 caster blocks and Rennbay track/performace ball joint kit installed. The ball joints have ~5k miles on them and the caster blocks ~15k. I am asking $250 for both plus shipping.
I would like to sell the complete setup, but I am willing to break it up if there are buyers for everything. If I end up breaking it up, I also have the front spring hats to use with other camber plates or factory front strut mounts.
I am asking $2000 for the struts, shock, springs, helpers, camber plates, and strut bar as a package plus shipping.
I also have a set of front control arms. The control arms are the early offset with the 968 M030 caster blocks and Rennbay track/performace ball joint kit installed. The ball joints have ~5k miles on them and the caster blocks ~15k. I am asking $250 for both plus shipping.
