thekidd

I took my hatch lock apart the other day to get ready to install a used cylinder with a new key on my 84 944. The hatch never worked and was missing the switch and probally a few peices that go near the rear lock cylinder. Got the cylinder and a new seal today, but don't know how to put the rear hatch arms and cylinder back together? Anyone have a picture of the rear hatch lock area? Are there 2 long screws that hold the lock in place? Or does the wire from the motor connect with screws to the cylinder?

MG944

I'll check a lil later and try to get a pic uploaded for you

Sour Kraut's 951

Not sure if this is what you mean but here is a pic of the lock mounted.

thekidd

Kind of, bit the whole mechanism. Can't figure out how the whole thing hooks up including motor piece. But I do not have the 2 long screws. But thanks, it helped a little bit