ritzblitz

prolly fipg
I used it before and it works

Are you planning to put a set together?

gregeast

I've never taken mine apart but I'd like to repaint my centers (Found this source for BBS gold rattle cans) and if I can figure out what size lip I have I'd like to replace the rears with the curb rash. Fipg is the stuff from Toyota, right?

ritzblitz

yeah toyota seal 102 iirc. I think its non silicon so it doesnt shrink.

What do you need to know for measuring the centers? I can help you with whatever you need to know.

Id have a paint shop paint the centers, they will turn out nicer than with a rattle can, and they will be more durable. Or have them powdercoated.

gregeast

Am I measuring from 'A' to the outer lip or from 'B'?

gregeast

Maybe a better question is what size lip you're using to get to 9 & 10?

ritzblitz

It depends on the offset initially.

You seem pretty confused about the measurements, the picture doesnt make sense.

Hopefully this killin pic i just drew helps you measure your lips. Its a side view fyi.

gregeast

There's no question I'm confused, lol!

Ok, the CAD drawing helps. My lips look more like this, which is maybe not clear in the picture and thus my confusion

ritzblitz

I know what you mean. Then measure the barrel like i showed and add half an inch for the lip. Then subtract from the width.