Good deal on CCW wheels
#1
Hey Man
Rennlist Member
Rennlist Member
Thread Starter
Good deal on CCW wheels
This is a steal for you early offset guys. They are hard to find at that price and they are very light. Not affiliated with seller.
CCW Wheels
Of course I am a bit bias.
CCW Wheels
Of course I am a bit bias.
#3
Nordschleife Master
Closest looking wheels to my favorite Fiske FM5's at half the price:
#5
Hey Man
Rennlist Member
Rennlist Member
Thread Starter
CCW still makes the 3-piece wheels like the 17" Classics 'Track' in my photo and also in 16". The ones in the ad came off of an 86 Turbo so hey would fit an early car (rolled fenders?) The lack of power on the NA would make it hard to push those 18x10's effectively and ruin the cars feel.
Trending Topics
#8
Almost Addicted
Rennlist Member
Rennlist Member
THAT is good to know, I love the FM5s also. I am going to wait until I do the v8 swap though, my car in is present condition cannot justify new wheels.
#9
He needs more rubber back there.
Those looking for 17's, I think I will be selling mine once I get the wide body on and the BBS wheels made up. Same ones in the avitar, 17X9.5 and 19X10
Those looking for 17's, I think I will be selling mine once I get the wide body on and the BBS wheels made up. Same ones in the avitar, 17X9.5 and 19X10
#12
Hey Man
Rennlist Member
Rennlist Member
Thread Starter
Thanks Darwin. I wondered about those offset numbers and now see those would only fit a modded body. That's some serious meat on that car. Is that anyone here selling them?
At first I thought it might be the same guy I bought mine from, he went to 18's and his 951 looked very similar.
Mine were off this car.
At first I thought it might be the same guy I bought mine from, he went to 18's and his 951 looked very similar.
Mine were off this car.
Last edited by KuHL 951; 09-24-2008 at 07:33 PM.
#14
Nordschleife Master
I've personally seen the wheels in question and they look fantastic and that is a good price, if only I had the cash but I'm already spending enough with my body work project.
#15
I've been in email contact with him. He is running 7mm rear spacers and there is a very slight rub on the wheelwell when the suspension is fully compressed. Fronts also rub slightly under compression and fulll lock turning. I have seen the pics, the rubbing isn't bad.
The reason I didn't jump on them is that that is just too wide of a rim out front for anything less than dedicated track use. You have to hack up a lot of the fender to make it work.
The reason I didn't jump on them is that that is just too wide of a rim out front for anything less than dedicated track use. You have to hack up a lot of the fender to make it work.