Driver kick Panel/Hood release
07-10-2006, 12:45 AM
#1
Racer
Thread Starter
Join Date: Jun 2006
Location: neither here nor there
Posts: 423
Likes: 0
Received 0 Likes
on
0 Posts
Driver kick Panel/Hood release
I think I am missing a trim piece on my driver side kick panel, around the hood release. I think I read certain parts of the hood release are a common failure. Does anyone or could anyone take pics of a correct kickpanel hood release so I can see if I am missing something. Thanks in advance.
The carpet flopped over onto my foot this morning, so something obviously isn't right, I am just wondering whether it is a missing/broken part or just some failed adhesives.....
The carpet flopped over onto my foot this morning, so something obviously isn't right, I am just wondering whether it is a missing/broken part or just some failed adhesives.....
07-10-2006, 01:14 AM
#2
Three Wheelin'
Join Date: Jun 2003
Location: Phoenix, Az
Posts: 1,854
Likes: 0
Received 0 Likes
on
0 Posts
one part is held on with 3 phillips head screws and the hand pull pivots inside that part to open the hood.
the cable attaches to the pivot point and slides into a sleeve.
it was about $8 from the dealer.
87951
the cable attaches to the pivot point and slides into a sleeve.
it was about $8 from the dealer.
87951