Early 944 Seats
07-23-2004, 07:18 PM
#1
AutoX
Thread Starter
Join Date: May 2001
Location: Western New Mexico
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Early 944 Seats
Our 1983 944 Project car is about to have its new interior installed next week. Before we get started our drivers seat foam is toast, and we have been looking at pickup up a used passenger side seat and moving over the hardware to make it a drivers seat.
Has anyone done this in the past? Can it be done?
Brian Minson
Editor
9, The DIY Porsche Magazine
http://www.9magazine.com
PS: Be on the look out with the September issue of 9 Magazine as Rennlist and 9 Magazine team up to help you repair, restore and maintain your Porsche.
PPS: John D. I need to get artwork from you for the full page full color ad, and I have our banners ready for you.
Has anyone done this in the past? Can it be done?
Brian Minson
Editor
9, The DIY Porsche Magazine
http://www.9magazine.com
PS: Be on the look out with the September issue of 9 Magazine as Rennlist and 9 Magazine team up to help you repair, restore and maintain your Porsche.
PPS: John D. I need to get artwork from you for the full page full color ad, and I have our banners ready for you.
07-23-2004, 07:44 PM
#2
Hey Man
Rennlist Member
Rennlist Member
I don't think it will work. Your tilt control will be on the inside where you can't get to it. PET shows different part numbers for left and right seats even for the foam plugs to rebuild them. I haven't tried so I might be way off base here. I have had both seats on my 83 apart to redo the foam though by building up the old shape, turned out well.